این نوع محصول جهت نصب سنگ های آنتیک طبیعی و مصنوعی، کاشی و سرامیک و ... بر روی سطوح صاف گچی و آجری، سیمانی و نیز نصب کاشی جدید بر روی کاشی قدیمی، ترمیم موضعی کاشی و سرامیک کف و دیواره ساختمان ، و نصب محصول بر روی دیوارهای پیش ساخته و ... به غير از مكانهايي كه ديوار با رطوبت مستقيم در ارتباط است. ، مورد است.فاده قرار می گیرد. اين محصول در بسته بندي هاي ۵ ، ، و كيلويي عرضه مي گردد.
The screw molding in this production line has been changed from cm to cm. The funnel has a capacity of kg, an outlet valve and molding material with valves equipped with valve controls, pneumatic tubes and accessories for the valve and pneumatic protection controls for four valves, an electric motor with a motor capacity of horses And the special gearbox for the artificial stone production line is m .
The vibration table in this line of production is the same as the dimensions and specifications of the automatic lines, but because of the production capacity, more than two vibration tables are used, which are parallel to each other for the four outlet valves. Dimensions x m with mm plate plate with two kg three-phase high quality Chinese engine with tray and balance table, four x x cm, chassis , and European central wagon chassis, with special metallurgical springs for pieces , Aerodynamic lattice surface
Offering a variety of traditional and automatic production line of artificial stone quartz artificial stone (two-way automatic production line of artificial marble and quartz with a production capacity of to square meters) for the production of sheets and stones of covetous caverns with vibrating press system of vacuum-sab, sink Quartz vibe press vakuum-sab, artificial gravel with vibe press vacuum system, flooring, elevators and interior flooring in slabs and smaller dimensions ...
* Note: Some companies have introduced a very low loading and gradient loading system, as well as a low-volume hopper profile to reduce the amount of sheet consumed, the production of a rail system with very poor spectacle characteristics and low maintenance without preserving , The lack of use of the gearbox at the top and cost for the horizontal space of the upper part and the installation of the engine in the bottom of the rail system, loading solids and .... In this case, some of the solids will not enter into the mixer when it falls into the mixer, and it will not be fully loaded, and will slow down due to the poor profile of the rails. The loaded angle should be between and degrees in the rail system. For example, in order to load at a height of meters, the mixer should have an angle of meters and should be used with a heavy -stroke