Flexible hoses are made of a thin stainless steel band formed as a tube , seamed by longitudinal welding and finally corrugated with convoluted profiles . It means that each corrugation is perpendicular to the pipe centerline and its movement is independent from other corrugations . We call them &#;low pitch&#; when corrugations are positioned too close to each other and &#;high pitch&#; when they are a little bit farther from each other

ENETAF SANE metal flexible hoses are kinds of flexible joints made of stainless steel which are applied with the purpose of eliminating vibrations generally on non-planar piping paths.Furthermore, they are useable in misaligned piping. They have upper most level of flexibility and pressure , internal corrosion and external abrasion resistance . Flexible hoses are made of a bellows as well as one or more layers of braids.  The metal  flexible hose  can be welded , flange type , male threaded and union nut type

For situations in which we need more bending flexibility, hoses with Ω shaped corrugations are applied that for the sake of increasing number of convolutions per unit length without thickness reduction of the bellows plate, they benefit from a longer lifetime in bend loadings. This type of flexible hose tends to return to its initial form when released from loading and also they are appropriate for vacuum situation. Ω shaped corrugations are more pressure resistant as well

Flexibility of a metal flexible hose is result of its convolutions bending. A flexible hose life time depends on its bending stiffness, working temperature, corrosive condition, pressure and applied vibrations. Braid doesn&#;t affect hose flexibility so much, but a flexible hose which is exposed to excessive tension, might over elongate and consequently the corrugations might get opened up. For higher pressures two braid layers are applied and for vacuum or extremely low pressure situations a corrugated hose without any braid might be used

If it is going to be dispatched immediately after coiling and packing, then the “hose” becomes a product, e.g. solar flex hoses. On the other hand, if it is going to be delivered as a “ flexible hose assembly” it must pass through at least one of the stations mentioned below. During these processes, the semi-finished products are subjected to one or several leakage tests. In other words, each product will have been tested at least times in total without any exceptions.