Hospital lights and environmental disinfectants In Nasirabad Industrial City ( Sale, implementation consultation )

Hospital lights and environmental disinfectants-1
Hospital lights and environmental disinfectants-2

Presentation of businesses
You can introduce your business services or products in this section.
For this purpose, be in touch with us.




Although the dose measurement system used in our study (FastCheck Mediland, Taoyuan City , Taiwan) is semi-quantitative, it allowed us to detect if the dose reached adequate values for disinfection and to repeat the application when the value was not satisfactory. However, each dose value exceeded the expected value. This demonstrates that the device was positioned correctly in order to avoid shadow areas, although it was necessary to properly place furniture and equipment to improve the irradiation of all surfaces. In the study conducted by Wong et al., the R-D Rapid Disinfector system (Steriliz, Rochester, NY, USA) was used in a tertiary care hospital to evaluate the incremental benefit of UV-C disinfection in isolation rooms after the discharge of infected patients. The employed robot used four detached sensors to directly measure the UV-C light [

A prospective open-labelled cross-over study was conducted in a -bed teaching hospital in Italy from April to June . To evaluate the effectiveness of the UV-C disinfection robot in reducing environmental contamination, sampling was performed in four different critical areas: single occupancy ward room, intensive care unit (ICU) isolation room occupied for a minimum of h, and operating theaters (OTs).

The UV-C disinfection robot (Mediland Enterprise Corporation, Taoyuan City, Taiwan) uses amalgam lamps (UV lamp NNI / XL Niederdruck VUV Strahler) and protective reflector technology to generate high-energy, broad-spectrum ultraviolet light (UV-C &#x; nm). The manufacturer of the lamps declares in the technical data sheet that the lamps have a filter that blocks radiation between &#x; nm, eliminating the possibility of producing ozone as a by-product of UV-C radiation. The UV-C device uses min disinfection cycles and multiple positions with minimal distances from high-touch surfaces. Due to the use of high-intensity UV-C radiation, the device must operate in unoccupied rooms. There are multi-motion sensors that shut off the device if any movement is detected inside the room being disinfected or if the door is accidentally opened. When the robot operates in accordance with these procedures, the manufacturer declares that the amalgam lamps produce no ozone gas and leave no toxic residues.



( Sale, implementation consultation ) `s other In Nasirabad Industrial City