Improving the cleaning and disinfection of high-touch surfaces is one of the core components of reducing healthcare-associated infections. The effectiveness of an enhanced protocol applying UV-C irradiation for terminal room disinfection between two successive patients was evaluated. Twenty high-touch surfaces in different critical areas were sampled according to ISO -, both immediately pre- and post-cleaning and disinfection standard operating protocol (SOP) and after UV-C disinfection ( sampling sites in each condition, in total). Dosimeters were applied at the sites to assess the dose emitted. A total of .% (/) of the sampling sites tested after SOP were positive, whereas only .% (/) were positive after UV-C. According to the national hygienic standards for health-care setting, .% (/) resulted in being non-compliant after SOP and only .% (/) were non-compliant after UV-C disinfection. Operation theaters was the setting that resulted in being less compliant with the standard limit (&#x; colony-forming unit/ cm

We are more than just a water pump company. Through our solutions and services, we touch millions and millions of people every day, without most even noticing. And with that comes great responsibility. A responsibility to respect, protect and advance the flow of water for people, businesses and the planet. Because at Grundfos, we believe that every drop contains infinite possibilities, and that water has the power to change the world. 

Our study has some limitations. Firstly, the non-homogeneous sampling for all of the settings, where a greater number of analyses were dedicated to the OTs rather than the ICUs or patient rooms: it was not always possible to proceed with the UV-C treatment at the patient discharge because trained personnel were limited and not always available. This problem underlines the importance of having dedicated personnel identifiable as that of the outsourced cleaning company. The use of new technologies could in fact be included in outsourcing contracts as an improvement action in the event of non-compliance in the cleaning service. These personnel could be adequately trained not only on the cleaning protocols to be adopted but also on infection control issues.

The disinfection of the air with UV-C is performed by irradiating the upper-room air only, the whole room when unoccupied, or the air flowing inside the air-handling units. The study conducted by McGinn et al. demonstrated the feasibility of using a UV-C robotic system to disinfect both air and surfaces in a radiology environment, where it was two and four times faster than currently used chemical approaches [

Although the dose measurement system used in our study (FastCheck Mediland, Taoyuan City , Taiwan) is semi-quantitative, it allowed us to detect if the dose reached adequate values for disinfection and to repeat the application when the value was not satisfactory. However, each dose value exceeded the expected value. This demonstrates that the device was positioned correctly in order to avoid shadow areas, although it was necessary to properly place furniture and equipment to improve the irradiation of all surfaces. In the study conducted by Wong et al., the R-D Rapid Disinfector system (Steriliz, Rochester, NY, USA) was used in a tertiary care hospital to evaluate the incremental benefit of UV-C disinfection in isolation rooms after the discharge of infected patients. The employed robot used four detached sensors to directly measure the UV-C light [