Engine room boiler controls contribute to the regular, efficient, and safe production of hot water or steam. Combustion and activity control adjusts the fuel consumption according to the required amount. The main executive control shows the hot water temperature or steam pressure and sends a signal to control the amount of combustion in which the amount of air and fuel enters the burner. The order of burning in the burner is generally on / off, high/low / off and gradual.

This type of pot or boiler is made up of connecting cast iron pieces called fins. Due to the ability to assemble and disassemble the cast iron boiler, it can be used in spaces where it is not possible to use a steel and integrated boiler. In fact, cast iron boilers are assembled and installed in the engine room. types of sections are used in the construction of each capacity of cast iron boilers, which are as follows.

Older hot water boilers operate without distilling water vapor from the gas vent. This prevents corrosion and component breakdown. The return temperature of the distillation boilers during operation is lower than that of the old boilers, which distills the water vapor coming out of the ventilator. This enables the condensing boiler to extract excess heat from the water vapor phase to the extraction liquid and increase the boiler efficiency. Some carbon dioxide dissolves in the distillation to form carbonic acid. While some condensing boilers are designed to control distillation that causes corrosion, other engine room boilers require equipment to neutralize distillation. Traditional engine room boilers that do not perform distillation operations mainly operate in the range of % -% combustion efficiency and distillation boilers operate in the range of % -% combustion efficiency.

Parallel controls use separate motors to regulate fuel flow and airflow, enabling each motor to be tuned throughout the boiler ignition range. During installation, to points are usually drawn to create a curve of airflow corresponding to the fuel flow. The air-fuel ratio can be varied along the ignition range to prepare the optimal ratio in different ignition conditions. Also with the use of electronic dampers, this method of control is very reproducible.

This type of pot or boiler is made up of connecting cast iron pieces called fins. Due to the ability to assemble and disassemble the cast iron boiler, it can be used in spaces where it is not possible to use a steel and integrated boiler. In fact, cast iron boilers are assembled and installed in the engine room. types of sections are used in the construction of each capacity of cast iron boilers, which are as follows.