Our acrylic fibers are produced using monomer acrylonitrile as the major monomer (over %), methylacrylate or vinyl acetate as the second comonomer (less than %) and a third comonomer for dyability, by Solution Polymerization and Wet Spinning using SNIA technology. In both dull and semi-dull product, Titanium Dioxide (max .%) is used. Also, in the process of production, the fibers are submerged in finish (finish of about .%) prior to packing.

یک خط اکستروژن ورق شامل یک اکسترودر (دو یا تک پیچ)، مجهز به تعویض صفحه نمایش به علاوه یک پمپ دنده، و به دنبال آن یک میکسر است.اتیک (گاهی اوقات یک بلوک تغذیه کواکستروژن که قبل از یک یا چند مجموعه اکسترودر اضافه شده است.، همانطور که قبلا توضیح داده شد) است.. ، تغذیه یک صفحه سطح منقضی می شود.

Like other manmade fibers, polyester fibers are produced using industrial methods and because of their properties are good substitutes for such natural fibers as cotton. This product is made by combining dimethyl terephthalate, monoethylene glycol or terephthalic acid (substitute for the raw material &#;dimethyl terephthalate&#;) in the vicinity of good catalysts. Titanium dioxide is used to make the product look semi-dull. Also, in the production process, the product is submerged in finish (of about .%) prior to packaging. The following are some of the major characteristics of this product.

Our acrylic fibers are produced using monomer acrylonitrile as the major monomer (over %), methylacrylate or vinyl acetate as the second comonomer (less than %) and a third comonomer for dyability, by Solution Polymerization and Wet Spinning using SNIA technology. In both dull and semi-dull product, Titanium Dioxide (max .%) is used. Also, in the process of production, the fibers are submerged in finish (finish of about .%) prior to packing. The following are some of the major characteristics of our products:

Consistent with SNIA technology, the production process for this product starting with the mixing of monomers as feedback input to the reactors for polymer solution in Dimethylformamide (DMF) in the Chemical Area through to fiber production, drawing, finishing and packaging is continuous and that at each stage samplings and controls are conducted and finally the product is graded and released in accordance with the test results. Bright, dull and semi-dull products are normal. The product is packaged in bales weighing ± kg and then put in covered polypropylene jute and rod guards. The bales measure ** mm. - tons of the product can be transported in a -foot container.