Quick, Reliable, Durable & Proven Design. It is virtually foolproof and indestructible. Seal off one end of the suspect tube(s) with either a rubber tube plug or the T-Handle with an attached nozzle; then insert the Vacuum Leak Detector into tube to be tested and depress the trigger, a loss of vacuum indicates a leaking tube. It has a filter system to prevent debris inside the tube from clogging the tool.

As a result of welding processes used to join metals together, the base materials near the weldment, the deposited weld metal and, in particular, the heat affected zones transform through various metallurgical phases. Depending upon the chemistry of the metals in these areas, hardening occurs in various degrees, dependent mainly upon carbon content. Again, this is particularly true in the heat affected zone (HAZ) adjacent to the weld metal deposit where the highest stresses due to melting and solidification result. PWHT, is designed to relieve a proportion of these imposed stresses by reducing the hardness and increasing ductility, thus reducing danger of cracking in the vessel weldments.

Visual testing is used for the detection of surface flaws and discontinuities. The effectiveness of the technique can be enhanced through the aid of such tools as mirrors, magnifiers, fiberscopes, etc. Quantification of indications can be augmented through the use of tools such as depth gauges, templates, displacement gauges, etc. AITIS team for Visual Inspectors are Certified and Experienced as well. We have a number of Certified Visual Inspector from ASNT, API, CSWIP / AWS, NACE and BGAS.

Low Frequency Electromagnetic Technique (LFET) are used to inspect storage tanks, other convex or concave ferrous surfaces, as well as nonferrous metal tubing/piping surfaces. It is used for detecting wall thickness changes in carbon steel storage tank floor plates. Low Frequency Electromagnetic Technique (LFET) products does not use permanent magnets, so are lightweight (under lbs) and are is easy to handle and transport.LFET-based tests require minimal floor preparation; it tests through coatings and determines top surface flaws from bottom surface flaws.

It s very accurate. Wall thickness measurements can be made, with the use of a MHz-focused transducer, to an accuracy of within .mm. IRIS is an ultrasonic based system for inspecting ferrous and nonferrous tubes from the inside. It is applied on almost any material. With the IRIS, accurate thickness measurementscan be taken at any location along the tube, so small changes in thickness are measurable and the exact location of pitting and corrosion can be determined. It is a fairly sensitive technique. The sensitivity achieved will depend on tube dimensions and tube cleanliness. In general, it can be stated that, it should be possible to detect a .mm defect in tubing up to inch which has been properly cleaned.Both ferromagnetic and non-ferromagnetic tubes can be inspected A three dimensional picture of the defect is obtained, thus the defect profile and its depth is provided.