However, in synthetic rocks of the Plast Cemetery because of its surface continuity and low water absorption, as well as the minimum micro-microscopic holes in the internal tissue of the rock and their water-tightness, this product has a frost tolerance of up to to degrees centigrade below zero, which is It has made it a great place in many cold and frost areas. And take the place of natural stones in these areas and replace them.
The method of installing nano-cement foam plasters is similar to the installation of ceramic. That is, a dry mortar layer is spread over the surface of the cement, and it is sprinkled on it with a cement slurry, and we plan to install the floors and align them. By creating a cement slurry, the kidneys cover the pores under the product and the rest of the slurry emanates from the flooring joints. By cleaning it, the product is simultaneously bonded.
Artificial stone production line with variety in design and color for interior and exterior decoration with the ability to produce various types of flooring products (antique mosaics) and decorative and windshields, as well as building adhesives and building additives with a production capacity of - sq.m. Working shift with the ability to upgrade and use the equipment and devices in this series in automatic and semi-automatic production lines
Loaded aggregate and adhesive materials with custom-made envelope with a sheet of four millimeters reinforced with an automatic pop-up valve with a width of cm and a length of m at an angle of ° to ° and one meter with a -hem stud, with a -wire tow meters, with two cast iron reels with bearings , kg capacity, with a -horsepower transmission engine and three-way horsepower
- But the volumetric mass is between and kg per cubic meter of synthetic stones that are ultra-light. But due to the use of certain materials in this type of product, the water absorption will be up to % (albeit by default and without the use of side materials), which are suggested for interior decoration. Unless they are added during the production of the relevant nanoscale material to reduce the water absorption of the outside of the building.