cable tray is actually a carrier guide bridge. which is used to transfer and organize electric wires and cables in the wiring system of buildings. Their main purpose is the safe maintenance and protection of electric wires and cables and guiding them in the designed paths. Production scope of all types of cable trays Cable tray thickness: between . and mm Width: to mm Length: to meters Material: galvanized sheet - steel - steel ST Coating type: galvanized Cable tray parts and accessories: Knee Three way _Intersection _Connector Wall supports Roof supports _Conversion Cold galvanized cable tray: It is done with a lower percentage of microns, approximately between and microns. This type of galvanized is not suitable for cold and humid areas. Hot dip galvanized cable tray: Because this method is done with a higher percentage of microns, it has a very high resistance to moisture. The hot galvanized cable tray covers to microns of the surface and this amount of thickness easily resists corrosion and rust.

Rolling Trays industrial series are designed for installation in their open-information cable lines and electrical wiring with a voltage of V. They are used for installation on the street, and within manufacturing, retail, office and residential buildings. Clear the way laying cable lines with metal trays allows further easy to maintain electrical and low voltage systems and to develop it. Side height trays in industrial series and mm, which allows you to lay more cable tray and increases the payload.

Material used: pre-galvanized steel, roll, GOST marks OH-MT- -PS .-.mm thick (a method of hot-dip galvanizing). For special applications (nuclear power, tunnels, tropical climate the aggressive environment, etc.), ladders, "LLM" and their accessories can be supplied in special versions galvanized by immersion. Cable ladder are calculated on a load bearing structural steel and not regulated by any standards.

Rolling Trays are designed to punch them in the laying open of information and electrical cables with a voltage of V. They are used for installation on the street, and within manufacturing, retail, office and residential buildings. Clear the way laying cable lines with metal trays allows further easy to maintain electrical and low voltage systems and to develop it.

Cable trays are made of galvanized steel - one of the most convenient and inexpensive devices for the construction of information and power cables. They are the most universal way of cable management and can save up to % of the cost of the work of laying cables. Lotka can further develop the basic electrical and low voltage systems of the building the most simple and affordable. Usually they are laid over suspended ceilings or raised floors that are easily dismantled. Trays set at an altitude of at least m above the ground or grounds maintenance. Basically, it involves laying tray hanger to the wall or ceiling. At the bottom of the tray with the transverse holes are made by molding the metal thickness. On the sides and corners of the tray are made extra ribs ("Ridge"). In the construction of the "lock" the tray removed sharp edges. Tray rolls in high precision and high-forming machine.