Rolling Trays industrial series are designed for installation in their open-information cable lines and electrical wiring with a voltage of V. They are used for installation on the street, and within manufacturing, retail, office and residential buildings. Clear the way laying cable lines with metal trays allows further easy to maintain electrical and low voltage systems and to develop it. Side height trays in industrial series and mm, which allows you to lay more cable tray and increases the payload.

Niroosazeh Parand designs and manufacture types of cable trays and ladders with standard punch density. We manufacture our products based on international valid standards. We provide a possibility to designs and manufacture customer-specific cable trays and ladders solution from early stage specification, created together with you, through prototypes to batch delivery due to technical engineering Knowledge, expert staffs, and last machinery technology.

Rolling trays perforated intended for laying them open information and electrical cables with a voltage of V. They are used for installation on the street, and within manufacturing, retail, office and residential buildings. Clear the way laying cable lines with metal trays allows further easy to maintain electrical and low voltage systems and to develop it. Holes in the bottom tray molded, which gives additional rigidity to the tray.

cable tray is actually a carrier guide bridge. which is used to transfer and organize electric wires and cables in the wiring system of buildings. Their main purpose is the safe maintenance and protection of electric wires and cables and guiding them in the designed paths. Production scope of all types of cable trays Cable tray thickness: between . and mm Width: to mm Length: to meters Material: galvanized sheet - steel - steel ST Coating type: galvanized Cable tray parts and accessories: Knee Three way _Intersection _Connector Wall supports Roof supports _Conversion Cold galvanized cable tray: It is done with a lower percentage of microns, approximately between and microns. This type of galvanized is not suitable for cold and humid areas. Hot dip galvanized cable tray: Because this method is done with a higher percentage of microns, it has a very high resistance to moisture. The hot galvanized cable tray covers to microns of the surface and this amount of thickness easily resists corrosion and rust.

Material used: pre-galvanized steel, roll, GOST marks OH-MT- -PS .-.mm thick (a method of hot-dip galvanizing). For special applications (nuclear power, tunnels, tropical climate the aggressive environment, etc.), ladders, "LLM" and their accessories can be supplied in special versions galvanized by immersion. Cable ladder are calculated on a load bearing structural steel and not regulated by any standards.