Wintech, aims to manufacture products which are of high quality, steady and unique within the sector, to be used safely in every area of life, and to provide service to as many locations as possible on earth under Wintech brand, in order to present these products within the frame of world-wide production concept. Wintech, acts in full compliance with the highest quality standards in every step from the beginning of the manufacturing to the delivery of the products to end-users, in the factories located at different countries in the world.

It is possible to recycle PVC profiles thanks to recycling. Profile production wastes, cut - broken parts can be recycled for cleaning, which can be used in re-profile production. Life Cycle Analysis (LCA) is a systematic approach to reveal the environmental impacts of products and services in detail. Today, this method, which is especially used to analyze and report the environmental impacts of the products, takes into account all stages of the life cycle, including the production processes, shipment, consumer use and disposal as waste after use.

As a company which is conscious about its environmental responsibilities, Adopen has determined methods and put them into practice in order to determine the environmental extents and effects of its activities during all of the phases and supporting processes starting from the manufacturing of the product until the completion of the shipment. Adopen will remain sensitive about all of its activities being carried out without causing environmental pollution. Therefore the following points have been adopted as our principles;

In order to maintain customer satisfaction, it is evaluated whether the customer’s conditions are met or not, and the changing expectations of the customer are shared with the employees; and product improvement as well as certification works are performed. Training courses are organized in order to raise vendor awareness, the smallest dissatisfaction about the product is taken into consideration and reform procedures are carried out.

The profile is placed on the cutting table. After making the necessary measurement settings, cutting is made. The most important point to be considered when cutting is to make a cut by adding the weld share ( mm for each end of the cut profile is mm in total.). It should be noted that the cutting angle should be ° or °. In other angles, the cutting angle should be at the specified angle. Otherwise, the corners are not exactly ° when welding.