Consistent with SNIA technology, the production process for this product starting with the mixing of monomers as feedback input to the reactors for polymer solution in Dimethylformamide (DMF) in the Chemical Area through to fiber production, drawing, finishing and packaging is continuous and that at each stage samplings and controls are conducted and finally the product is graded and released in accordance with the test results. Bright, dull and semi-dull products are normal. The product is packaged in bales weighing ± kg and then put in covered polypropylene jute and rod guards. The bales measure ** mm. - tons of the product can be transported in a -foot container.
Licensed by E.I. Du Pont De Nemour based in the US, Acrylic Factory # has been producing Acrylic Fibers in Iran for three decades. The major monomers used in the production of acrylic fibers are acrylonitrile (AN), methylacrylate (MA) or vinyl acetate (VA). The acrylic fibers from Acrylic Fiber Factory # are produced using Slurry Polymerization and Dry Spinning. The fibers from Acrylic Factory # can be produced with a detex of .- dtex and a cut length of - mm and can also be produced variously on a customized basis. The factory is also capable of producing microdenier fibers. Good tenacity and uniform dyability are among their other outstanding characteristics. The production technology as well as the overall, physical and mechanical characteristics of the fibers is such that they have placed them in the Dralon products by Bayer, Germany. The following are some of the characteristics of our product:
دستگاه های جوش چرخشی- اصطکاکی شرکت KLN و Mecasonic مجهز به سروو موتور و تکنیک های مدرن کنترل بوده و بالاترین دقت و کارایی را در جوش قطعات با سطح مقطع دایره ای و متقارن ارائه می دهد. شرکت میلاد فراصوت همکاری نزدیکی با دو شرکت KLN آلمان و Mecsonic فرانسه داشته و آماده خدمت رسانی در زمینه تامین انواع تجهیزات جوش چرخشی می باشد.
Like other manmade fibers, polyester fibers are produced using industrial methods and because of their properties are good substitutes for such natural fibers as cotton. This product is made by combining dimethyl terephthalate, monoethylene glycol or terephthalic acid (substitute for the raw material dimethyl terephthalate) in the vicinity of good catalysts. Titanium dioxide is used to make the product look semi-dull. Also, in the production process, the product is submerged in finish (of about .%) prior to packaging. The following are some of the major characteristics of this product.
تمامی این روش ها در مرحله ی اول شامل اینترکشن میان مونومرها به منظور تولید پلیمر است.. زمانی که پلیمر تشکیل شد، طی فرآیندهای مختلف الیاف تشکیل میشوند. هم اکنون بیش از . درصد از الیاف اسپاندکس در دنیا به روش خشک محلول ریسی (solution dry spinning) تولید میشوند.