In commercial complexes, the boiler is very different in summer and winter, night and day, working days and weekends. Using a boiler can not apply this load difference well. When the heat generated by the boiler at the lowest ignition rate exceeds the heat required by the building, the boiler cycle will be interrupted. Starting and interrupting the cycle in the boiler is not efficient at all because, in each cycle, a pre-combustion discharge and a post-combustion discharge are performed to direct the heat out of the boiler. Also in the case of boilers that do not perform the adjustment operation, when the combustion efficiency is at its best, the cycle process does not allow the boiler to operate in the second boiler and the ignition rate is constant.

It gives us an immense pleasure to deliver this appreciation letter to you as result of your diligence and professional service to our mill.ALMEDA TEXTILE PLC appreciates your service and invaluable assistance you give to our co-workers. If we had an award to give, you would be the key expert in this regard.Please accept our sincerest gratitude for the superior service you have offered in our mill Again, thank you so much. We greatly appreciate your generosity

CATEC is one of the few companies in Egypt that offer REAL technical support. Your staff is kNowledgeable and can offer help anytime by all means. Many agents and company partners for famous manufacturers come to me and tell me we will support you after sale .. I tell them support is not about reporting a problem and sending an email and wait for reply, WE CAN DO THAT! Support is about being on site solving the customer`s problem and let the customer kNow why and how to deal with this problem in the future .. And this is what CATEC does !!

As mentioned earlier, any type of waste, such as soot or sediment, that covers the boiler heat transfer surface will reduce efficiency and increase the likelihood of parts and equipment failure. Cleaning of this surface is necessary according to the manufacturer&#;s recommendations for the life of the equipment and to maintain the optimal performance of the boiler. The waste that covers the boiler pipes prevents heat transfer and raises the temperature of the aerator gas. If incomplete combustion occurs, the resulting soot will accumulate in the part of the pipe where combustion has taken place. Similarly, inadequate water treatment in the water sections of the pipes causes sediment to accumulate in these sections. Only a .-inch-thick layer of soot or sediment can reduce heat transfer by up to . percent, and a .-inch-thick layer by percent.

The burner combines fuel and oxygen to create combustion conditions with the help of a combustion device. This combustion takes place in a combustion chamber and the heat generated is transferred to the heat exchanger water. The controls regulate the combustion process, the ignition rate of the burner, the required fuel, the amount of air required, the water temperature, the steam pressure and the pressure of the engine boilers.