Sepehr Electric high pressure updraft evaporative coolers (also referred as upflow). The air cycle operation of this device is to pulling the air from outside the cooler. Once the air is cooled inside the cooler, it is sent upward by the blower, creating an updraft of air. This air flows into ducts that spreads the cool air through the house. The perfect place to install this unit is either on trusses or balconies, you can certainly install and perfectly use them on the roof too.

All Sepehr Electric vented gas heaters are equipped to three different safety systems: ) environment oxygen control system (Oxypilot ODS), this fully stops the gas flow upon oxygen lowering in the room to less than normal limit. ) Thermocouple, the thermocouple automatically shuts off the gas flow if the flame of the heater is turned off accidentally. ) Pressure governor, the governor will permanently regulate the input gas pressure in order to control and stabilize the output pressure in a safe and certain range.

Same as our free-standing water heaters, our wall-mounted water heaters come also with a built-in tank to keep water continuously hot and ready to use. The advantage of this range is to occupy less space while offering low energy consumption with a high output to meet the user’s maximum level of expectation, including durability. Our wall-mounted gas water heater comes in liter capacity, while our wall-mounted electric water heaters are available in the sizes between to liters.

Sepehr Electric high pressure updraft evaporative coolers (also referred as upflow). The air cycle operation of this device is to pulling the air from outside the cooler. Once the air is cooled inside the cooler, it is sent upward by the blower, creating an updraft of air. This air flows into ducts that spreads the cool air through the house. The perfect place to install this unit is either on trusses or balconies, you can certainly install and perfectly use them on the roof too.

Cellulose water coolers share almost similar air cooling qualities like the Aspen pad coolers. What makes them different from each other is the kind of evaporation interface. In cellulose water cooling systems, compact cellulose pads are used instead of aspen pads. Cellulose pads are made of cellulose paper sheets which are very thin, with high capillary and absorption capability. These pads are regular and wavy in form, have some certain grooves, special groove angels and function with water up to temperature of º. It is recommended to maintain the pH level of the water between and .