Engine room boilers have capabilities that have made them the main and common part of buildings. Boilers have a long life, and boiler efficiencies can achieve efficiencies of % and above, provide effective methods for heating buildings, and require very little or zero pumping energy in steam systems. But fuel can be significant, and regular maintenance is required by the facility engineer, and if it is delayed, the cost of repairing the engine room can be high.

The presence of large amounts of accumulation of insoluble solids (TDS) in the boiler water can cause sedimentation and reduce the efficiency of the boiler. Therefore, it is necessary to keep the number of solids below the specified limit. As the total hardness increases, the likelihood of sedimentation and sedimentation increases. Drainage of water, called pot immersion, requires the removal of some of the undissolved solids and keeping the total hardness below the rate at which it precipitates. Low but constant and frequent submergence of high doses but rarely is better because it preserves energy, water, and chemicals. Large boilers with a constant load must be continuously submerged where small amounts of water are constantly drawn from the boiler and fresh compensation water is produced.

Parallel controls use separate motors to regulate fuel flow and airflow, enabling each motor to be tuned throughout the boiler ignition range. During installation, to points are usually drawn to create a curve of airflow corresponding to the fuel flow. The air-fuel ratio can be varied along the ignition range to prepare the optimal ratio in different ignition conditions. Also with the use of electronic dampers, this method of control is very reproducible.

Eng. Shamel, I wanted to thank you and CATEC team as well for taking time from your busy schedule to support and help Americana meat KSA on all utilities projects (steam boilers, thermal oil heaters, etc). I kNow some of the work wasn’t part of your normal responsibilities, but your assistance was invaluable in helping my company get everything done in a very timely manner. Your expertise and enthusiasm were both appreciated during a time which can be stressful for all concerned! We sincerely appreciate your efforts and thank all CATEC team

The best ways to maintain and operate a boiler start with maintaining a regular schedule of reviewing reports and checklists to ensure proper equipment operation. Pressure, water temperature, and vent gas temperature reports should be recorded daily so that they can be used as a basic reference for troubleshooting system performance. More detailed checks and checks should be important to provide system performance. Without this, there may be gradual changes in system performance over time that are not clearly visible. Tips for achieving performance efficiency include, for example, daily, weekly, and monthly inspection reports that you can apply to the building. The following maintenance checklist is provided based on the methods used in this article.